Contact Us
TEL: +86-510-86180056
Fax: +86-510-86189830
E-mail: zhouzhen0404@hotmail.com
Address: No.219, Nanjiao Road, Nanzha Town, Jiangyin, Wuxi, Jiangsu, China (Mainland)
Home > Knowledge > Content
Characteristics of Single-phase EI sheet in Different Production Processes
Mar 23, 2018

The single-phase EI sheet is mainly used for making cores of various motors, generators, and transformers. Because of the special conditions of use, the requirements for the production quality of single-phase EI sheets are relatively strict and the technology is more complicated. For example, the hot rolling process can be used for production.

 

In the hot rolling process, the metal alloy wire is heated to a molten state, and then repeatedly hot-rolled into a thin plate, and finally, annealed at 800-850°C. The hot-rolled single-phase EI sheet is mainly used for the manufacture of generators, but the availability of this process is low and is gradually taken by other processes.

 

The other is a cold-rolled non-oriented single-phase EI sheet produced by a cold rolling process. The silicon content is 0.5% to 3.0%. After cold rolling to the finished thickness, the supply specifications are mostly 0.35mm and 0.5mm thick. . The Bs of cold-rolled non-oriented silicon steel is higher than that of oriented silicon steel.

 

Compared with hot-rolled silicon steel, this type of single-phase EI sheet product not only has a uniform thickness, but also has a higher dimensional accuracy and a smoother surface, thereby increasing the fill factor and the magnetic properties of the material. Another type is called cold-rolled oriented silicon steel sheet. Compared with the cold-rolled non-oriented silicon steel, the oriented silicon steel has a strong directionality in magnetic properties; it has superior high magnetic permeability and low loss characteristics in the easy magnetization rolling direction.

 

In addition, there is a process called high-inductance cold-rolling process. The oriented single-phase EI products produced by this process are mainly used in various transformers, chokes and other electromagnetic components in the telecommunications and instrumentation industries. manufacture. This single-phase EI sheet is usually made using a thin strip of 0.05-0.20 mm.

http://www.ht-siliconsteel.com/


Previous: Three-phase EI sheet production requirements and processing technology

Next: Slip line resistance selection and advantages of 3 Phase EI Lamination with holes