Contact Us
TEL: +86-510-86180056
Fax: +86-510-86189830
E-mail: zhouzhen0404@hotmail.com
Address: No.219, Nanjiao Road, Nanzha Town, Jiangyin, Wuxi, Jiangsu, China (Mainland)
Home > Knowledge > Content
Replacement operation steps for laminated silicon steel sheet
Nov 22, 2018

Laminated silicon steel sheets are mainly used to make iron cores for various transformers, motors and generators. Do you know how to replace the silicon steel plate during the lamination process? The first step is to disassemble the laminated leather. At this time, the upper cover of the laminating machine needs to be opened, and the laminated skin and the upper cover are cut by a utility knife.

The next step is to disassemble the laminated silicon steel plate. At this time, use a screwdriver to unscrew the screw that can be screwed off. For screws that are broken inside or cannot be screwed out, the same diameter electric drill should be used to punch holes, and the holes should be punched again. Care should be taken not to drill the threads on the upper cover during operation.

Then use a utility knife to cut the strip around the laminated silicon steel plate, remove the silicon steel plate, and use the hard tool to remove the rubber left in the upper cover groove. Remember, the glue in the groove must be scraped clean. Then put the silicon steel plate into the laminating machine, put all the screws on, pay attention to the plate and plate should be placed tightly, and confirm that the screws are well fastened.

https://www.ht-siliconsteel.com/


Previous: No-load characteristics test and iron loss measurement of single phase core transformer

Next: Material and structural characteristics of ultra-thin UI silicon steel iron core